the cube · drawer module

the cube

drawer module

modern minimalist drawer module design inspired by the cube movie

full dimensions in mm ~ x:200 · y:200 · z:200

- 0.28mm layer height - 10% cubic infill

this design takes about 1.5kg of filament and quite a few hours of printing , it's designed to be robust and have a “heavy” presence, therefore I did not approach it with a filament saving mindset (thinner walls, grids, etc)

also the tolerances are relatively tight, therefore cannot guarantee that if you scale it down that the drawers will slide in properly, so I don't recommend scaling it down . Another important consideration is to make sure that you have proper bed adhesion as to not have any lift, therefore i recommend using 3DLAC to ensure everything stays nice and flat

notes

- includes bambu studio 3mf file and STLs - all photos uploaded are of the actual printed model, and are copyright protected - if you enjoy this model please consider to

https://www.buymeacoffee.com/h3li0

commercial licence membership available on my

patreon.com/h3li0