Flush Cutter Holders - Remix! (Original Work by Dan H)

This is not an Original Model, this is a Remix of the Side Cutter Holder made by Dan H, I give him full credit for this work. Reference link to original attached.

I have some Cutter Holders already, and they work Absolutely Fantastic, But I have a problem with rough wood surfaces that I need them "Stuck" to, and that just doesn't work, believe me I've tried, many times. So just to clarify, No Problems with my current holders, only problems with My Surfaces and Sticky tape.

So I set out to find one I could simply put a screw in, Since tape sticking to the wood was the problem, "Screw It" seemed the easy solution. (Pun Intended). However I didn't immediately find any that were Quite what I was looking for. I then Stumble upon these bad boys by Dan H, Under a Remixable License! There was only one reasonable thing left to do, Abandon the quest to find the "Perfect" Holders for me, and begin Remixing them.

Currently I use these to hold Cutters, Scissors, and Pliers so I've remixed them into some slightly different shapes, and have two "Sizes", with each size having two variants. 10mm and 20mm for the Small, 50mm and 60mm for the Large. I prefer the small for my Cutters, Large for Scissors.

I know these are pretty Niche as most people don't want to go around putting screws into their workspace, But mine happens to be almost all Wood, We're talking Cheap Pine that I have no qualms putting screws into, because Yeah, the tape would probably stick Way Better if I paint it, but I find this a Far Easier solution than that, so Here we are. Anyway moving on.

Thank you @Dan H, I Appreciate You and Your Work!

Design Concept

This model is designed as a holder for side cutters, enhanced with features to ensure a snug fit and easy access. The minimalist design focuses on stability and functionality, making it both practical and aesthetically pleasing.

Function

Ideal for organizing side cutters in workshops or tool sheds, these holders provide a neat and accessible storage solution.

Printing Recommendations

Requires minimal support when printing. A standard layer height of 0.2mm with a 20% infill should provide sufficient strength. Use PLA or PETG for durability.

Assembly Instructions

The holder should be securely mounted to a wall or tool board using screws for safe and secure use. Ensure it is installed at an easily reachable height for convenience.