X1C dual stage Chamber Filter

Here is my two-stage filter to purify the air expelled from the chamber of our closed printers. It is a replacement of the original activated carbon filter.

I designed it to accommodate both a Hepa filter and activated carbon , in order to eliminate a greater quantity of impurities from the air before it is expelled from the printer.

As you can see it is very simple to use:

- fill the lower half with the activated carbon - place the grid and place the Hepa filter on top (it is a common cheap filter 80x40x15 mm) - Insert it into the printer as you would do with the original filter - Close the filter vane and you are done. It took you longer to read than to do it! If you want to be able to use a larger quantity of activated carbon, I have designed a variant with a larger container: you can see it by clicking on the image below.

If you print materials that require a completely enclosed chamber, you might want to print my internal powerful air filter. You can check it out by clicking the image below!