universal cable holder screw-edition

Hello Community,

From now on, there is an official model of my universal cable holder that can be screwed in place.

You can use it to attach cables up to a diameter of 8 mm .

All print profiles have been tested by me with the A1 Mini and work perfectly .

Instructions

The screw holes have a diameter of 4mm , allowing the use of 3mm screws without any issues . In most types of wood, 3mm screws can be screwed in without pre-drilling and without causing the wood to split. However, this should be assessed individually and cannot be generalized.

A long driver bit is recommended for screwing it in place. Additionally, screws should be tightened carefully, as too much pressure can cause the printed layers to split apart. I tightened the last part by hand , as it allows for better control .

Have fun with the model

I would greatly appreciate any feedback.

Should there be any problems, please contact me!

Feel free to check out my other models

CABLE HOLDER TAPE EDITION

CABLE HOLDER IKEA-SKADIS EDITION

Boost Me I would be very happy about a boost