Small Trash Bin or Storage Can For Cars TPU Lid

2 Plates Trash Can with TPU Lid Just a simple garbage bin, trashcan, storage bin, etc I created in Tinkercad. Has a TPU lid with flaps to help hold in the trash or stash.

***PLEASE CLEAN YOUR BED PROPERLY BEFORE PRINTING. DAWN DISH SOAP(Or Equivalent) AND HOT WATER THEN DRY WITH PAPER TOWEL OR AIR DRY!! NOTHING ELSE NEEDED!! THIS WILL ENSURE YOUR PRINT IS SUCCESSFUL***

##  These printed as shown but if you dont clean your bed properly and have adhesion issues, then you can add a brim or mouse ears. I test all my prints and it is proven to print as I set it up. ##

A small storage container or trash bin I designed in Tinkercad that has a TPU lid. Just slide it over the top of the bin. It may be a little snug but it will help hold it securely on top.

I used a carbon fiber plate to give it a cool carbon fiber look.

You may have to squeeze the upper cap a bit to help it slide down over the base piece as its a tight fit but designed to help hold it in place. You may have to stick your finger inside the flaps to help adjust it a bit but when the lid is on  it should stay on pretty well.

Simply pull it upwards to open it and remove trash or items you may have collected.