AquaBounce

Keep Cool & Bounce All Summer with AquaBounce!

AquaBounce is a 3D printed trampoline sprinkler attachment designed to fasten to the top bar or safety-net poles of a trampoline using standard cable ties.

Once connected to your garden hose using a Hozelock-style quick connector, it sprays water over the trampoline to help keep summer play cool and fun.

This was designed after my shop-bought trampoline sprinkler broke, so I wanted to try making a printable version.

Features:

- Fastens to trampoline safety-net poles or top frame bars - Uses cable ties for fitting - Fits Hozelock-style quick hose connectors - Designed for outdoor summer water play - Easy to print Extra Parts Needed:

- Hozelock-style quick hose connector - Small rubber O-ring/gasket for better sealing - Cable ties for mounting The exact connector pack I used is no longer available, but it was the same style as this type of set:

https://www.amazon.co.uk/EUHUYG-Connector-Fitting-Set-1Nozzle-Waterstop/dp/B089W2GM1P

The O-ring/gasket is not strictly required, but it helps reduce leaking. I reused one from an old Hozelock-style hose attachment. Without the O-ring, it may leak slightly but should still spray.

Safety Notes:

Use AquaBounce carefully and follow your trampoline manufacturer’s normal safety rules.

- Adult supervision recommended - Use with safety net and padding fitted - One person at a time - No flips or rough play - Use water only, not soap - Stop using it if the trampoline surface becomes too slippery Water Pressure Tips:

For the best spray:

- Use a shorter hose where possible - Check the hose is not kinked or blocked - Avoid splitters or timers if they reduce pressure - Make sure valves are fully open At my property, with the tap fully open, it had enough pressure to spray across a 12ft trampoline. Results may vary depending on your water pressure and hose setup.