Falconsson - Foldable tripod/monopod

- The tripod has an adjustable tilt head and is compatible with the standard 1/4-inch camera mount. - Compatible with my “phone clamp for tripod” design - In its folded state, it occupies minimal space and is easy to carry. It can also be used as a monopod. - This was my first design, and it has now been completely revised. The overhangs have been cleared and the tolerances have been fine-tuned. It can be printed in less than two hours with around 50 grams of filament. It doesn't require supports or additional hardware to print. - For screw tolerances to work right, it must be printed with dimensionally accurate filament. PLA, PLA+, PETG, and HIGH SPEED PETG are recommended. - To increase rigidity, the hinge screw can be replaced with a 45 mm M5 bolt, and the plastic camera mount can be replaced with a standard 1/4-inch metal one, though this is not essential. Print Settings

It is recommended that you use the 3MF file provided with the design, it is tested.

İnfill density: 65% for screws, 10% for else,

infill pattern: gyroid

Support: Not required

Wall line count:2

Top/Bottom Layers: default (4,4)