Sochi Autodrom 3D Miniature

3d miniature of the Sochi Autodrom in Russia!

This miniature has been completely re-created for improved printability & full multicolor support! 🎨

Printable Frame:

https://makerworld.com/en/models/2691009-printable-frame-for-3d-miniatures

GIF of the printable frame

Check out my collection of other miniatures:

https://makerworld.com/en/collections/146964-all-miniatures

Collection of other Motorsport / Racetrack miniatures:

https://makerworld.com/en/collections/450282-motorsport-f1-miniatures

🖌️ Coloring Details

Filament colors used in the model photos:

- Bambu Matte Red (racetrack) - Bambu Matte Ash Gray (buildings & roads) - Bambu Basic Dark Gray (vegetation) - Bambu Matte Black (terrain) - Sun-lu Dark Gray / Sun-lu Sky Blue (water) - Bambu Matte Black (frame) These colors are based on personal preference and the filaments I had available.

Try experimenting with different color combinations to suit your style!

I highly recommend Matte filaments!

This model looks great even if printed with a single color, so an AMS is not necessarily required.

🖨️ Slicing & Printing Details

This model was designed to be printed with a 0.4mm nozzle and 0.16mm layer heights.

Try using a 0.2mm nozzle (0.08mm layer heights) or scaling up for even finer detail!

Note : If roads or other small details disappear after slicing, try lowering the extrusion/line width of external perimeters (outer walls) closer to 0.4mm OR use Arachne walls (can also enable “Detect Thin Walls”).

🖼️ Framing Details

This model measures almost exactly 6.7in by 4.7in (170.5mm X 119.5mm) and should fit most 5x7 frames (assuming frame lip/overlap is around a quarter inch). Feel free to change the scale/size of the model(s) to meet your needs.

Personally I use these cheap frames from Amazon: https://www.amazon.com/dp/B0C8HY7YSQ

And blue printer paper: https://www.amazon.com/dp/B00006IDQT

(non-affiliate links)

I've also uploaded a fully printable frame (including a 1mm thick water plate) designed to fit all my miniature cities!

For this model, I actually printed the water plate with a light-gray filament and used that in my frame.

A frame is not required! This model looks great by itself and can be displayed almost anywhere.

Model created in Blender using data primarily from the Blosm addon.

Membership Subscribe for a Commercial License to sell physical prints of my models! License stays valid as long as the subscription is active.