The Throwing Knife

0.2mm layer, 2 walls, 15% infill A well-balanced throwing knife designed for smooth, consistent throws.

Features a sharp, clean edge and a simple, durable design optimized for 3D printing.

Easy to print and ready to use or display.

13 minute print. yes only 13 minutes. (NO SUPPORT)

Sharp on both side (NO SUPPORT)

Scale to any size. (might need support if u want it BIG)

Denser tip, better for throwing, reduced time, 100%/15% PLA Denser at the tip by modifying the density profile better for throwing

reduced time

Durability Focused Settings Improved finish quality, final smoothing, and a slightly heavier weight for better feel on the cast.

0.2mm layer, 2 walls, 10% infill scaled up to be 225mm long to better fit my hand. takes about 33 minutes on the bambu A1 but if you want finer detail you might want to add some supports to the print.

2, 3, and 4 color versions. Looks great! Added color options for customization. Enjoy!

Fits your finger and print by object enabled It is big enough to fit on your finger and you can rotate it on your finger before launching it.

The settings used in this print profile has print by object set so that you can print in two colors without any wastage.