Uchiha Itachi + Relief Plaque - Naruto

0.2mm layer, 2 walls, 7% infill This has been sliced at an angle throughout the centre avoiding any direct cuts to the face or birds

Supports are non invasive a couple of tricky ones need to be removed from under his cape although they are inside This has been sliced at an angle throughout the centre avoiding any direct cuts to the face or birds Supports are non invasive a couple of tricky ones need to be removed from under his cape although they are inside and arent visible when connected together although perfectly removable,

There are plugs but for some reason my slicer altered the final size and they are very tiny so need to glue a couple just for alignment,  and a very small section of his hood on the left hand side unfortunately gets sliced but it prints beautifully and can easily be glued back in place once entire model is assembled

0.2mm layer, 2 walls, 7% infill New settings applied with adjusted support removal plus new print profile for a medium sized model

0.2mm layer, 2 walls, 7% infill New settings applied with adjusted support removal plus new print profile for a large sized model

Relief sculpture 0.2mm layer, 2 walls, 5% infill

Relief sculpture 0.2mm layer, 2 walls, 5% infill