Two Paws, One Heart - Puppy Couple Heart Charm

0.2mm layer, 2 walls, 15% infill I design cute and meaningful 3D models inspired by love, animals, and everyday happiness.

Each piece is created with care to bring warmth, charm, and a little smile to your day.

My designs are perfect for decorations, gifts, bag charms, keychains, and small collectibles - especially for pet lovers and special occasions like Valentine's Day.

Recommended Print settings ( FDM - PLA)

Basic

- Layer height: 0.2 mm - Nozzle: 0.4 mm - Walls / Perimeters: 3 - Top / Bottom layers: 4 - 5 - Infill: 15 - 20% (Gyroid or Grid) Quality

- Print speed: 40-60 mm/s - Outer wall speed: 30 mm/s (for smooth finish) - Enable Z-hop: optional (0.2-0.4 mm) Supports

- Supports: Not needed (if model is flat on the back)

* If your slicer detects small overhangs:

-Use “Build plate only” support

Adhesion

- Build plate: Brim (3-5 mm) recommended for small parts - Bed temp: 55-60 degrees Celsius - Nozzle temp (PLA): 200-210 degrees Celsius For keychain / bag charm durability (Optional)

If you want it stronger:

- Increase walls to 4 - Infill 25% - Enable “Ironing” on top surface (for premium look)