Disneyland California 3D Miniature

3d miniature of Disneyland Resort in Anaheim, California!

Includes both Disneyland Park and Adventure Park!

Check out my collection of other miniatures: https://makerworld.com/en/u/1935755220/collections/146964

Walt Disney World Magic Kingdom miniature: https://makerworld.com/en/models/216013#profileId-235139

Created in Blender using data imported with the Blosm addon.

Slicing & Printing Details

This model was designed to be printed with a 0.4mm nozzle ( 0.16mm layer heights ) or a 0.2mm nozzle ( 0.08mm layer heights )

I have uploaded two different print profiles for each nozzle size with the recommended settings pre-applied ready to slice and print!

Each print profile includes two different models of Magic Kingdom, one with suspended monorail tracks and another with grounded tracks (no overhangs).

Suspended Monorail Tracks

Grounded Monorail Tracks

Note : If paths or other small details disappear after slicing, try lowering the extrusion/line width of external perimeters (outer walls) closer to 0.4mm OR use Arachne walls . Can also try enabling “Detect Thin Walls”.

The included designer print profiles have the above settings pre-applied!

This model also includes a small wheel for Mickey's Fun Wheel / Pixar Pal-A-Round. Personally I attached it with a tiny bit of superglue.

Filaments used in photos: Sunlu Matte White (miniature), Bambu Matte Black (frame), Sunlu Sky Blue (water)

Framing Details

This model measures almost exactly 6.7in by 4.7in (170.5mm X 119.5mm) and should fit most 5x7 frames (assuming frame lip/overlap is around a quarter inch). Feel free to change the scale/size of the model(s) to meet your needs.

Personally I use these cheap frames from Amazon: https://www.amazon.com/dp/B0C8HY7YSQ

And blue printer paper: https://www.amazon.com/dp/B00006IDQT

I also included a fully printable frame (including a 1mm thick water plate) designed to fit all my miniature cities.

Gif of the Printable Frame

A frame is not required! This model looks great by itself and can be displayed almost anywhere.

I've also created an OpenSCAD script to create custom labels! Create your own here:

https://makerworld.com/en/models/3249849-parametric-label-creator

Membership Subscribe for a Commercial License to sell physical prints of my models! License stays valid as long as the subscription is active.