Gridfinity IKEA Bilresa Remote Control Holder

A custom Gridfinity-compatible smart home remote holder for the IKEA Bilresa remote control.

The design allows the remote to be easily reachable at an angle. It is useful when you have a grid on your office desk and control Matter devices. I use it as a light switch and to control a fan in the room.

It is a solid Gridfinity Extended bin (2x1x6) with a custom cutout for the remote. The file was created with Fusion 360, and the project contains a ZIP file with the f3d file in case you want to make any changes.

The remote will sit quite tightly in the holder. To remove it for battery replacement, you can use a small tool (toothpick, tweezers, small pocketknife, etc.). I also added a 3mm hole so you can push the remote out from the back. I used a short piece of filament.

Printing Notes:

- Prints without supports

- A brim is recommended to prevent warping

Credits / References:

- Based on the Gridfinity system by Zack Freedman

- Gridfinity base generated using Gridfinity_Extended_OpenSCAD by ostat and used as the base