Pcub3D - BYOC - 30 Scale Mud Pit

This model is for use with the Pcub3D - BYOC Modular Mounting System (BYOC System).

The MUD PIT, specifically made for 30 scale to run through, but any scale can use it as a transversing obstacle.  Fill with 6mm airsoft BB's and let her rip.  BB's WILL come out of pit especially if you overfill it.  Only fill it until you can just see the top of the little grab handle in the tray.  If you need help moving, turn your wheel back and forth and attack middle and exit ledge at an angle.  I like to clear some of the bb's with my tires right before exiting to minimize spillage.  FUN FACT:  A clean dust buster will pick up the bb's that fall in the BYOC holes and easily transfer them back into the pit or container.  Start your fill low and then add/replace as needed.  Your wife/mom/GF will thank you.

This is a new supplementary system to the common MakerWorld Crawler Course/Park plates out there.  This system solves the storage issue of big bulky plates and saves a ton of money because you only have to print the number of BYOC plates you want once and then you can put whatever obstacles you want onto your plate and change it as many times as your want.  Best of all it is FULLY COMPATIBLE with the common connection system found on MakerWorld that are supported by many other course designers.  This system is meant to supplement your course building…NOT change it.  You can orientate most obstacles in 8 different directions and can even mount across plate joints.  NO MORE wasted crawling space!

To use this terrain obstacle you will need to print a BYOC Base Plate and screw in Pins found HERE .

More BYOC Models