Springy Kitty Flexi Fidget

2 plates, with and without AMS plate 1: multi color

plate 2: single color

Layers carefully tuned for minimum Time & Material Waste Layers carefully tuned for minimum Time & Material Waste many many substantial value adding adjustments also that result in low filament material waist and quick print time with reasonably good strength…

see the specifics below…

2X Height range modifiers to controls base layers and over hang detection at lower levels of the model.

0.28mm layer, 1 walls, 1mm wall width, 0% infill, wall generator arachne, detect over hang walls off, detect narrow internal solid infill off, ensure vertical shell thickness disabled, acceleration speed [ short travel , initial layer travel, initial layer, outer wall, top surface ] all turned up to 10000mms. max volumetric speed for PLA, and PETG both set to 27mm3/s, cooling for over hangs set to 100%, minimum fan for layers less than 4 seconds 100% and for the other layer times 100% and auxiliary part cooling fan 80%.

note that filament flow, and cooling settings will likely revert to default and acceleration speed will also likely revert to default if you use a different Bambu printer.

SILK and print quality optimized

Split By Color, Push Fit, Parameter optimization This is a modification on Hajimi's Parameter Optimization, which separates the eyes and nose allowing users without an AMS print the model in color

The derivative parts use tolerances of 0.09+-, sanding might be required if your 3D printer is not tuned correctly

KEY KEY

0.2mm layer, 2 walls, 10% infill

参数优化，提高打印效率