Amazing Digital Circus Ragatha Wall Art

I've already uploaded a silhouette wall art model of Zooble, Jax, Kinger, Gangle, Bubble, Caine, and Pomni.

You can check those out here .

I've continued working on my efforts to complete The Amazing Digital Circus Character Silhouette Wall Art Series…. So, FINALLY, here's RAGATHA!

This final character, rounds out The Amazing Digital Circus, and is uploaded to correspond with the theatrical release of The Amazing Digital Circus: The Last Act.

PLEASE REFRAIN FROM SPOILERS UNTIL THE YOUTUBE DEBUT

If you would like additional characters, such as Abstraction, Ribbit, Kaufmo, Queeny, Gummygoo, Princess, or any of the others, please just let me know and I can do them.

My preferred method of mounting on wall is Scotch® Mounting Putty™. However, Scotch® Frog Tape™ or just Scotch® Double Sided Tape™ will work as well.

Assembly Difficulty on a scale of 1-10 is going to be at a 2 (two).

Minor assembly required.

I’ve continued my efforts to expand certain line segments to make mounting easier, but unfortunately, Ragatha requires pieces that I cannot connect to one solid line. It is one of the reasons that it's taken me so long to finish.

The entire print takes less than 20 grams of filament and in under 60 min†!

† Print Times May Vary

Perfect last minute gift for any kid’s birthday!

Ragatha has been scaled to fill the build plate of P/X Printers (256x256x256). If you have a larger printer, you can scale it up, but I recommend keeping the thickness set at 1mm for best results (0.80mm works too) but you can select whatever thickness you prefer.

An A1 Mini profile will be added and available shortly.

You can support me by giving the print a 5 star rating, liking my models, following me on {MakerWorld}, or giving my models a boost!

You can also visit my website or chip in to buy my next roll of filament .

Feel free to follow me for more characters, but I have considered this series finished. Again, if you’d like more of The Amazing Digital Circus friends to be added, just let me know! I may include additional prints of characters, but I haven’t decided! Many hours of work have went into these models, and I thank you so much for your support! I couldn’t do it without you!

As always, enjoy! If you have any issues, please don't hesitate to reach out to me directly, by going through my website , message me on MakerWorld or comment below.

https://www.enderlabs.org/

https://makerworld.com/en/@EnderLabs

Notice: I am not responsible for any damage to walls or mounting surfaces. Use best judgement when affixing to surfaces.