Leatherface Door Topper - Laser Version

Nothing says welcome quite like a chainsaw hanging over the doorway. 😂

This chainsaw-maniac laser door topper turns the corner of an ordinary doorway into a miniature horror scene. The character peers over the top of the frame with a chainsaw raised while the opposite arm reaches down alongside the trim.

The larger character design provides plenty of room for the facial, clothing, chainsaw, and shading details to come through in the engraving while maintaining a strong silhouette from farther away.

The included SVG contains the detailed raster artwork for engraving along with a red vector outline for cutting.

Tested Material & Laser Settings

These are the settings used to produce the finished example shown in the photos.

Laser: 40W xTool Material: 1/4" (6 mm) Pine Ponderosa Plywood

Engraving: Power: 40% Speed: 100 mm/s Passes: 1 Bitmap Mode: Jarvis Resolution: 100 lines/cm Engraving Mode: Bi-directional

Cutting: Power: 100% Speed: 4 mm/s Passes: 1 Kerf Offset: Off Lower Focus: Off Tab Generation: Off

The red vector outline is the cut line and the detailed raster artwork is intended for engraving .

These settings are the actual settings used for the pictured example. Results can vary with material and machine condition, so verify settings on your own material before running the complete project.