Tesla Charger Plug Holder - Death Star -Secure Fit

THAT'S NO MOON!

IT'S A MUCH COOLER AND MORE SECURE WAY TO HOLD YOUR TESLA PLUG!

Tired of your charging handle dangling in the garage like Luke on Cloud City? This Death Star wall mount locks your Tesla connector in place using pure geometry—no tractor beam required.

Designed to keep your cable organized and off the hangar floor, it holds the plug snug so it won’t slip into the dark side of your garage clutter. The fit is precise enough to survive a trench run, keeping the connector secure until your next departure.

Install:

- Two versions, with cable holder and without. You only need to print one. 4 tiny supports to remove with pliers. - Drill guide provided. Probably throw a level on it. You likely only need to use two screws. Go into a stud or use appropriate anchors for the mounting base. Holes are 6mm smaller in metric or #8/#10 in Emperial sizes. ;) - Slide the Death Star down over the base latches. Secure with one 4mm or #6 screw (ideally course thread) 20-30mm (1 or 1.25 in) long. Don't over tighten, especially if it's a drywall or other countersink screw. - Recommended in PETG or ABS/ASA. May the charge be with you.