U.S. Army M1A2 Abrams MBT - Kit Card — Image 2 of 8

U.S. Army M1A2 Abrams MBT - Kit Card — Image 3 of 8

U.S. Army M1A2 Abrams MBT - Kit Card — Image 4 of 8

U.S. Army M1A2 Abrams MBT - Kit Card — Image 5 of 8

U.S. Army M1A2 Abrams MBT - Kit Card — Image 6 of 8

U.S. Army M1A2 Abrams MBT - Kit Card — Image 7 of 8

3D model · MakerWorld

U.S. Army M1A2 Abrams MBT - Kit Card

Platform: MakerWorld
Price: Free
License: PRIVATE-USE; Personal use only: print for yourself, no selling or sharing.
Formats: 3MFSTL

299 Likes
718 Downloads
405 Makes
662 Collected
20 Boosts
48 Comments
0 Views

Author:N3D

Published 2024-05-28

Download on MakerWorld

Description

Membership Printed at .08 layer height with an initial layer height of .16mm. Due to the angles on the hull, this was the best way of reducing the the layer ridges

Be careful when removing from the bed as you'll rip the side supports if you're too eager.

Use snips to cut the supports, and an exacto knife to trim.

Place the gun in it's position by forcing it upwards into the turret as you hold the block at the back of the gun, it will go in, but its a tight fit.

If you like this print, please support me with a boost, it's much appreciated.

Guides and print profiles

Print profiles and steps

0.08mm layer, 2 walls, 10% infill Printed at .08 layer height with an initial layer height of .16mm. Due to the angles on the hull, this was the best way of reducing the the layer ridges

Be careful when removing from the bed as you'll rip the side supports if you're too eager.

Place the gun in it's position by forcing it upwards into the turret as you hold the block at the back of the gun, it will go in, but its a tight fit.

If you like this print, please support me with a boost, it's much appreciated.