Trash Can

The original webpage for this post is on Printables. It was transferred here through the automated system, so some formatting, file links, etc. may not work as intended. Please see Printables for original post or see my full collection of designs on Cults3D . -Abby

Trash Can with separate Lid or as a Solid Model

Original design for the 2024 Christmas Community Print Drive .

Two versions are included: Solid Model and Bottom/Lid version with two parts. My kids insisted that I create the design that opens after I started with the solid version. The lid prints without supports by bridging across the opening that goes around the brim of the open can.

More Models: Collection of all approved 2024 Christmas Community Print Drive models

More Options: More sizes that fit inside each other available at @Cults3D: https://cults3d.com/en/3d-model/various/trash-can-abbymath

Additional Information and Print Settings

The model is approximately 55 x 55 x 71 mm. I printed with 0.25 mm layer height, 2 perimeters, 3 top and bottom layers, and 15% infill. No supports. No raft.

If you are printing for the Community Print Drive , be sure to use the appropriate guidelines: 2024 Christmas Community Print Drive Printing Guidelines

More of my designs on Cults3D: https://cults3d.com/en/users/abbymath

Not for commercial use. No derivatives. See license below.

Note: Most photos from earlier, smaller model. Print Drive standard models are posted here.