Ghost Rider

Do NOT adjust the size in your slicer!! The layers will not come out right. Do not change the size, this will cause errors in color change compromising the entire print. Use my print profile or you will not get the desired results. It can be printed safely without AMS and on any printer. I hope you like it, I hope you like it, if you want to support me leave a like and vote five stars thank you! Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 180x180mm in size You may print at higher layer heights below the Min Depth of 0.48mm The Max Depth is 2.2mm and the Actual Depth is 2mm

Filaments Used: PLA BambuLab Matte Charcoal Transmission Distance: 0.1 PLA BambuLab Basic Silver Transmission Distance: 0.7 PLA BambuLab Matte Ivory White Transmission Distance: 1.7 PLA BambuLab Matte Scarlet Red Transmission Distance: 1.8 PLA BambuLab Basic Yellow Transmission Distance: 5 This print uses 5 unique filaments

Swap Instructions: Start with Charcoal At layer #7 (0.64mm) swap to Silver At layer #10 (0.88mm) swap to Ivory White At layer #13 (1.12mm) swap to Charcoal At layer #18 (1.52mm) swap to Scarlet Red At layer #20 (1.68mm) swap to Yellow At layer #22 (1.84mm) swap to Ivory White for the rest.