Box opener plastic knife with teeth and bambu logo

0.08mm layer, 3 walls, 100% infill

0.28mm layer, 3 walls, 15% infill Modified to remove the bambu lab logo and increase layer height for faster print.

- 0.28mm Layer Height - 3 walls - 15% gyroid infill

0.2mm layer, 2 walls, 15% infill Normal 0.2mm layer

single color, 0.12mm layer, 3 walls, 15% infill single color, infill reduced to 15%, layer height increased to 0.12mm for faster print speed

Fine details (no logo) - 0.08mm layer, 3 walls, 5% infill Uses a lower layer height and slower speeds to get better details which can also improve the opener in use.  also removed the logo to make it more universal.

PLA BAMBU COLORS 0.08mm layer, 3 walls, 100% infill BAMBULAB COLORS. Slightly smaller version for easy transport. A beautiful green line in the center makes the project much more refined and eye-catching. Printable in 42 minutes.

0.08mm layer, 2 walls, 15% infill Aggiunto un gancio per poterlo attaccare alle chiavi o a ganci in cucina, laboratorio ecc

0.28mm layer, 3 walls, 15% infill, 8mm Magnet Cavity Printer will pause after layer 8. Place an 8mm(or smaller) into cavity. Resume print.

Optimize parameter version More delicate printing of variable floor height top surface Change the order of wall --- interior wall, exterior wall and interior wall FIRST FLOOR ONLY SINGLE WALL "TO AVOID MINOR HOLES IN FIRST FLOOR Speed is adjusted and suspension deceleration is closed within a reasonable range (this model has no overhang) Add Skirt

0.6mm nozzle, 0.3mm layer, 3 walls, 100% infill