Unifi U7 Pro Wall Desk Stand
Unifi U7 Pro Wall Desk Stand — Image 2 of 5
Unifi U7 Pro Wall Desk Stand — Image 3 of 5
Unifi U7 Pro Wall Desk Stand — Image 4 of 5
Unifi U7 Pro Wall Desk Stand — Image 5 of 5
3D model · MakerWorld

Unifi U7 Pro Wall Desk Stand

Model details

Platform
MakerWorld
Price
Free
License
CC-BY-NC-SA
Non-commercial use only, with credit; share remixes under the same license.
Formats
3MF
  • 220 Likes
  • 1 596 Downloads
  • 1 315 Makes
  • 893 Collected
  • 78 Boosts
  • 129 Comments
  • 0 Views

Author:Fatih Arslan

Published

Download on MakerWorld

Description

Desk Stand for the Unifi U7 Pro Wall from Ubiquiti. This stand is similar to the aluminum premium desk stand that Ubiquiti sells, but like all its offerings, it's always out of stock.

I created this because I wasn't sure if I wanted to wall mount the U7 Pro Wall.

Usage:

- Attach the metal plate to the U7 Pro Wall using four M3 bolts. The best bolt length is around 5mm, but I used 10 mm, and everything worked fine. - Print it sideways; see the picture I attached. - Print details : - Print in PETG, ASA, ABS (anything that works better with high temperatures) - Use infill of at least 50%. I used a Gyroid pattern. It works fine. - Use a brim because it's large. - Use tree support, and you don't need any blockers. The slicer will handle everything else.

Guides and print profiles

Print profiles and steps

0.2mm layer, 2 walls, 50% infill This profile follows the instruction of the designer but no print profile was available. Hope you find this helpful!

Still the same directions as posted by the original designer:

- Use four M3 bolts to attach the metal plate to the U7 Pro Wall. The bolt length is best at around 5mm, but I used 10 mm, and everything worked fine. - Print it sideways; see the picture I attached. - Print details : - Print in PETG, ASA, ABS (anything that works better with high temperatures) - Use infill of at least 50%. I used a Gyroid pattern. It works fine. - Use a brim because it's large. - Use tree support, and you don't need any blockers. The slicer will handle everything else.

0.2mm layer, 2 walls, 50% infill, A1 Mini Print profile for the A1 Mini!

Tags

unifiu7 pro wallu7 proubiquitiap

Comments

Loading comments…
More like this

Similar models

Names are used only to indicate the source of a result. Polyzon is not affiliated with the listed sites.