Modern Christmas Trees

0.2mm layer, 2 walls, 15% infill 0.2mm layer

2 walls

15% infill

Sizes 100%, 80%, 60%

0.28mm layer, 2 walls, 0% infill used 0.28mm layer and it still turned out looking good, 2 walls, 0% infill, slowed down 1st layer speed and added a brim for it to hold to the plate since the middle is empty.

0.2mm layer 2 Walls VaseMode Fast No hole at the top This is a better version of my old one where some had problem with hole at the top now fixed it. :)

[Vasemode] 0.2mm layer, 1 walls, 0% infill Slowed first layer for better adhesion,

3 trees on 3 different plates

Heavier Bottom: 0.2mm layer, 2 walls, 15% & 5% gyroid infill I wanted a heavier bottom so the decoration sits more stable and thus added a modifier that has a 15% infilled bottom and then a 5% infilled top part. I also separated each tree on its own plate so it becomes easier to print them mutlicolored without AMS.

Smooth & optimized for speed Structure only where needed, and you still get a smooth top