Shaving Cream & Razor Organizer

Decided to make my own shaving cream/razor/brush etc bathroom organizer.

I printed the knob using fuzzy skin in the Prusa slicer as this will hide all imperfection and provide a better look & feel. I used a M4xH6 hot insert in the knob and small M4 screw on the inside of the drawer.

Printed the Top Base on a textured plate to complement the fuzzy skin look of the knob. The dark 3 Blue parts are placed in the hole area as support but with the spacing between the part and the blue support parts they will slide off easily and if not that's why the 2 indented holes are there for helping of the removal. If the finish is not a desired look after the removal of the support I also printed the 3 hole fills in 1.5mm thick and crazy glued it in the holes which provided a better finish.

The bottom support for the razors is also crazy glued to the inside of the base.

The Top Base is then crazy glued to the bottom base.

I textured the bottom base outer sides only in fuzzy skin to complement the textured look.

I also used fuzzy skin on the front part of the drawer only not including the center hole where the knob goes into.

All parts printed in PLA & no support required

Note : Because of the large parts I had some thermal shrinkage of the top part which may appear that its slightly thinner when viewed in the front but not really noticeable. Also had some thermal shrinkage on the drawer near the back which again is inconsequential.