Mini Construction Cone

I wanted a miniature construction cone that can stack with others. I actually use these when one of my cats pukes as a caution sign for anyone else in the house to avoid until it can be wet vacuumed and fully cleaned.

For different layer colors I use the switch filament option in the slicer.

- Write down the total layers - Figure out how many layers the base is. - Subtract the total layers from the base layers which gives you how many layers in the cone part and divide by how many transitions you want. - Add the layer thickness measurement to the base count to give you the first layer change. - Continue adding the layer thickness count each time.

Suggested print settings:

- Infill: 100% - as there isn't much wall thickness and a heavier base is nice - Layer Height: 0.2 - No supports should be needed.