Elegoo Centauri Carbon adaptor for segmented poop chute

I wanted to build a poop container for my Centauri but didn't like the idea of having to rebuild something else once the ams came out for it. Since I already had one of the “(The original) Bambu lab segmented poop chute pipe” models on my P1s I thought this would be great for the CC too. It's nice because you can just use a bucket or container to let the poop fall into and you don't have to empty it as often.

I didn't use any special settings to print just three walls, gyroid infill, tree supports and an outside brim. I've printed it with both pla and petg and they both worked great. It needs four 12mm x 3mm magnets. I'd recommend gluing the magnets in. Fit into the chute opening is snug. As with all production models fit may vary. The two Centauri Carbons I had access to it fit perfect in. This model uses parts from https://makerworld.com/en/models/40524-the-original-bambu-lab-segmented-poop-chute-pipe#profileId-41116 You need only the segments if you are going to use a container to run the pipe into. I would suggest petg for the segments as it makes them easier to connect and pull apart. Also use and inner and outer brim on the segments as there's not a whole lot of contact area with the build plate. Other than using a container, the other option is to print the tray for use until the Elegoo ams comes out. Then you can put the pipe into a container.

I'd like to thank @Alvsjc1 for the use of his adapter model. It's a great adaptor for the X1C and the P series printers for the same segmented poop chute https://makerworld.com/en/models/599256-bambu-poopchute-adapter-for-x1c#profileId-522668

I hope you get some great use out of this.