Peg Perego Ride On Wheel Driver Insert Adapter for 24v (6 gear motors)

I upgraded my Peg Perego John Deere Gator XUV ride on car to 24v. The upgraded motor has 6 gears and requires an adapter to connect to the factory wheels. This model will attach to the motor and connects to the red inner wheel driver insert. Depending on your motor setup you might need to add washer shims before the axle bolt to keep the wheels tight.

I highly recommend printing in PETG with the gear at a 45 degree angle. Just add supports to keep it in place. Make sure your support top gap is low (around 0.12).

Print Settings:

Material: PETG

- Walls: 6 - Infill: Triangle - 40% - Top/Bottom layers - 6 - Layer height 0.2 to 0.28