Fast-Printing Toothbrush Holder (Vase Mode)

This (very) fast-printing toothbrush holder has been designed to print in vase/spiralize mode for quick printing times and low filament usage.

It has a simple and modern hexagonal design, and holds either two or four toothbrushes with no bottom underneath to allow for proper drainage. It also has a flexible back, which can open slightly to make cleaning the inside easy.

On an entry level printer, this only takes around 40 minutes (2x toothbrush version) or 65 minutes (4 x toothbrush version) to print.

I use a 0.6mm line width for increased strength. As this is designed to be printed in vase-mode, no supports are needed.

The design prints upside down (as oriented in the STLs), so please flip after printing.

I have uploaded a standard version and also a slightly wider version (for larger toothbrushes)

I hope people find it useful.

Enjoy :-)

If you find this useful, please check out my other designs on Prusa Printers and https://cults3d.com/en/users/LR3DUK/creations

Update: I have uploaded a version of the 2 toothbrush holder with a wider base (increased diameter by 10mm) to increase stability for larger toothbrushes (Filename:ToothbrushHolder_DoubleWider2). The STL can be easily scaled in the slicer to increase the size further if needed.