Flashforge AD5M - Enclosure attached tool holder

This is a tool and nozzle holder for the Flashforge AD5M enclosure kit.

It has been designed to fit to the far left corner and positioned to fit to the Standard Enclosure panel screw places. You will need to change the original M4 screws to a bit longer ones.

It has room for all the standard AD5M tools and nozzles plus some more as you can see on the picture. You can add a scraper, there is a small box for stuffs like filament clips, you can add one more screwdriver and a Caliper.

It was designed with a small offset of the nozzle holder to be able to remove the left side plexiglas panel without a hassle in case it's needed.

Printing details:

- I made it from PETG with 15% infill, you can try PLA but I would go with at least 30% infill with PLA as it is less strong material

- Supports: it needs support only for the cutting pliers holder (see the pic)

- With 15% it consumes about 167g material