Carbon 13 TV Head

It's my Dummy 13 TV head , but updated to fit the Carbon 13 joint

Not much more to say.

Assembly is even simpler than before, as this design no longer requires screws to hold the face in! Just snap in the joint like the original models, and push in a face!

Note: Previous faces are not compatible with this head! Please use the faces included on either this page or the D13 TV Head V3 page! (Want a specific expression? Just message me & ask!)

Faces snap into place, & can be ejected from below with the included face remover. To use the face remover, insert the curved part facing towards the neck, (Extrusion forward) & push in. It should pop the face right out! If not, give it a wiggle, you'll get it eventually. I believe in you.

Since the Dummy 13 and Carbon 13 use different joints for their heads, make sure you grab the right file! Note: The F and M versions of the C13 have distinct joints, but this should fit both. To be safe though, use the F version's joint.

At 200%+ scale, you can simply use your finger to eject the face.

Note: If you want to sell this print, use the D13 version! Both heads are cross-compatible