Dragon Egg

Instead of using threads to fasten the egg together, this model uses magnets! The small baby dragon will fit inside!

Print Instructions: Required Hardware: 6 - 6x3mm magnets for the egg

Supports: Not required. However, if you want the inside of the egg to look neat toward the top you might consider adding support there if you'd like.

Assembly: When placing the magnets, ensure the magnets placed in a way where they attract each other when the tray is attached to the pot.

Happy printing!

For those who have joined my club at the “Obsessor” tier or have subscribed to my commercial membership on Patreon , prints of this model can be used for commercial purposes.

Feel free to join my discord for additional support, questions, or suggestions!