Adhesive Cable Clips for Swedish Installation Cables

Parametric snap-in cable clips designed for round Swedish installation cables.

The clips have a completely flat base intended for double-sided adhesive tape.

The cable is pressed through the top opening and held securely by the flexible clip body.

Important sizing information:

Cable type and conductor size do not always guarantee an exact outer diameter. Dimensions may vary between manufacturers and product generations. Always check the actual cable diameter before printing a large number of clips. The outer diameter is included in every STL filename so that the correct model can be selected by measurement.

- Material: PETG recommended - Print orientation: Flat adhesive base on the build plate - Supports: Not required - Layer height: 0.20 mm - Perimeters/walls: 4 - Infill: 30–40%

PETG is recommended because the clip arms need to flex when the cable is inserted. PLA may work, but it is generally stiffer and may become brittle over time.

Mounting: Clean the mounting surface before applying the double-sided tape. Use tape suitable for the surface, temperature and expected load.

Safety notice: This is a 3D-printed cable-management accessory and is not a certified electrical installation product. Verify that the mounting method and cable installation comply with applicable local electrical regulations. Do not rely on adhesive mounting where a detached cable could create a hazard.