why would you print this vase mode pen cup

It doesn’t print fast. It uses too much filament. It takes up a lot of space. It does a barely passable job holding pens. But it’s swirly and you love it, don’t you? Yeah… I know what you like. Go ahead, I know you’re gonna print it.

Print instructions

This is vase mode (the best mode) cup. While that’s the only real requirement, here are the setting I used:

- Spiral vase mode / Spiralize outer contour: turn this on, this is how the whole magic works - Line Width: 0.7mm ( but 0.5mm or 0.6mm should work as well ) - Layer Height: 0.3mm ( not necessarily required, but I like to keep things fast ) - Bottom Thickness / Bottom Layers: 1.2mm (e.g. 4 layers at 0.3mm layer height) - Wall speed: 30mm/s ( you are pushing a lot of plastic, so a slower speed is best, though if you are confident in your hot end you can go faster ) - Printing Temperature: +10 degrees hotter than your usual temperature - Flow: 110% ( because why not ) Note

The model in the photos was printed on an Elegoo Neptune 2 with a 0.4mm nozzle in Polymaker PolyTerra arctic teal PLA.