Voron Prime Pellet Bucket

A little bucket designed to hold small priming pellets made during the Print_Start macro.

There are 2 versions of it, one that simply bolts to the front of the frame, and the other is held in place by 2 6mmx3mm magnets to allow for easy removal/dumping of the pellets.

Each version has a 250/300/350 size bucket. Tested and confirmed fit on a 350 but the smaller sizes should fit.

I have provided an example (I have been using for over a month) of the priming macro below. This is for a 350 and it assumes you have already leveled the bed/gantry and have the proper z offset/auto_z calibration.

Obviously, use this macro as a guide/reference and check it over and understand what it is doing before going full send on it.

[gcode_macro PRIMING] gcode: M106 S255 ;partcooling fan max CLEAN ;call clean macro G1 X5 Y5 F15000 ;move to purge position G1 Z0.3 F3000 ;move to purge position G91 ;incremental positioning G1 Z0.2 E30 F3 ;prime hotend G1 Z2.0 E25 F30 ;purge and move up G1 Z4.0 E20 F60 ;purge and move up G1 Z2.0 E10 F240 ;purge and move up G1 Z10 F3000 ;move up by 10 G1 Y55 Z-18.25 F3000 ;move to wiping start G1 Y10 F3000 ;wipe back G1 Y-10 F3000 ;wipe forth G1 Y10 F3000 ;wipe back G1 Y-10 F3000 ;wipe forth G1 Y-55 F3000 ;wipe end and kick off the poop pellet M107 ;turn cooling fan off G1 Z2.0 F3000 ;move up M82 ;extruder absolute G92 E0.0 ;extruder reset G90 ;absolute positioning M107 ;partcooling fan off

#------------------------------------------------------------------------

[gcode_macro CLEAN] gcode: M204 S6000 ;set acceleration to 6000 G1 X5 Y35 F15000 ;move to position G1 Z0.5 F3000 ;move to position G1 Y1 F10000 ;kick the prime tower off

#------------------------------------------------------------------------