F1 Logo Keychain (Formula 1)

Introduction

I wanted an F1 logo that looked nice that I could put on my keychain for fun, so I created this. It prints pretty quickly and with minimal materials and overall comes out looking pretty nice in my opinion.

Printer

I printed this on my Ender 3 Pro.

Print Settings

I use Cura as my slicer so the settings below will be named accordingly.

- Z Seam Position: Back Right - Infill Density: 15% - Infill Pattern: Quarter Cubic - Print Speed: 80mm/s - Supports: No - Build Plate Adhesion Type: Skirt