Aperture Science 40mm Fan Guard/Grill

Aperture Science strikes again, as a 40mm fan guard/grill.

Simple and elegant.

Print Settings

Printer:

Ender 3

Rafts: No

Supports:

No

Resolution: 0.16mm

Infill:

20%

Filament:

3D Solutech PLA White

Notes:

Remixed mvanallen's design in Blender because the original aperture logo is actually at another angle; for purists, you should flip it over so that the spokes face the right way (mine isn't like that to match the extruder knob)

No reason to print fast since it's so small and thin, you definitely want proper definition. Do note that from my testing, this does make the fan a little louder (most likely because of the small gap created behind the center of the logo where the fan still manages to pull air from).

Goes well with https://www.thingiverse.com/thing:3116871 if you want to keep the theme going.

Category: 3D Printer Accessories