Talon Claw and Talon Claw U Caliburn Back End Parts

Parts for a talon claw and talon claw U to make it compatible with caliburn back ends.

Makes the prime of the talon claw the same as a caliburn equivalent at the cost of some fps.

Can use any stock spacer except the thumbhole stock.

-Use 13 inch threaded rod for threaded rod version and use talon claw u with stock U channel for the u channel version

-use full 11 inch caliburn springs with these parts, most likely usable with other 11 inch springs of any kind as well due to not pushing the plunger as far back.

-requires a stock spacer tube

-Use the talon claw plungers not the full length plunger, it will jam on these prints

Remix of https://www.thingiverse.com/thing:2376150

https://www.thingiverse.com/thing:3981538

Print instructions

Print Settings

Printer Brand:

Prusa

Printer: I3 MK3S

</div> Rafts:

Doesn't Matter

Supports: No

</div> Resolution:

.1-.32

Infill: 20

</div>