Square Hinged Retainer Case with Magnetic Closure

Thank you @DaveRawks_776760 for the original model!

I like the original model but the hinges were at a steep angle and would always come out looking sloppy using PETG.

So I modified the hinges so they would not print at an angle and would not need supports.

Also, since I printed this in PETG, I had to set the " X-Y contour compensation " to -0.1 in OrcaSlicer. Without this setting the print-in-place hinges would fuse together and never release. PLA may work differently.

The magnets are 6mm x 2mm.

Filament pictured is Flashforge PETG - Burnt Titanium

(one of the prettiest PETGs out there. Why aren't there more colorful PETG filaments out there like this one?)

I included the .3mf file for printing on the BL P1P.