Expandable Steel Sheet Holder for Prusa Enclosure

Remix for installing Whity's Steel Sheet Holders on the side of the Original Prusa Enclosure. Only for MK sheets.

You only need to print one of each part. If you need more holders, rest can be original unmodified versions.

Print instructions

Print settings are same as in original model.

Original instructions when I made this remix:

Print with 0.2mm layer height. No supports needed.

- Rotate the side parts 50° to fit on the print bed. - Adjust the "Fill Angle" by 50° too Assembly Instructions

Remove 4 x nylon rivets holding the clear panel to the frame.

From inside, insert M3x6 and M3x12 screws and fasten them to M3 nuts in printed parts (see photo).

Update 10.2.2024

New version for mounting on the bottom of the enclosure. Sheets are accessed from the side of the enclosure. Mounting with 4 x M3x6 and 4 x M3 nuts.