LEGO Discovery Space Shuttle Wall-mount

This is a refined version of the model I'm actually using - this model has the shuttle sitting bit closer to the wall than you see in the picture.

For strength, I recommend that you print in PETG 20% infill and in the orientation you plan to mount it in so that the layers run the length of the mount. There is some flex built-in. This has been sitting on my wall for weeks without any issue.

Unfortunately, the print requires supports. I'd definitely love it people revised the design with no supports necessary. It's my first real try at designing, so there!

To mount:

Two screws into stud/drywall anchors using screws with a 4-5mm head.

Mount at an angle of 20-40 degrees.