Coffee capsule dispenser / pod holder for Nespresso and compatibles

Coffee capsule dispenser / pod holder for Nespresso and compatibles

It has been designed to hold one box of 10 capsules although printing several units will allow them to be ganged together side by side as desired

If anyone needs a multi-print version, let me know and I'll upload it.

Just open the capsule box, cut to leave a square open end. Insert in to the top or the dispenser until it reaches the stops.

The design allows the stacked capsules to descend through the shoot where they are guided to a horizontal position ready for picking.

The capsules can be loaded either with the tops facing left or right. I find it works well if the capsules are each alternated sequentially left and right.

The dispenser works very smoothly and the removal of the capsule in the tray is easy with the sculpted access each side of the dispenser tray for a finger and thumb.

Supports are required for the overhang above the exit shoot.

Printed in PLA at 0.2mm on my Prusa Mini+

I've included STEP files so modifications can easily be mode. (It's my belief that STL files should be phased out as they are hard to modify and adapt)

Please upload your makes

Hope this helps someone