Junction Box A mount for Canyon H31

This is an old design that I imported from my prints on Thingiverse.

I made this Di2 junction A mount for my Canyon H31 Ergocockpit with Garmin mount. This will hide most of the junction out of sight but you can still use all the functions. The leds can be seen between the Garmin mount and the junction mount from above and below. And to change it you can easily lower it as it will held at the back with an little velcro. The front slots onto the Garmin mount. I also added a spacer for if your cycling computer touches the mount.

After printing you remove the support and it should fit fine.

Print Settings

Printer:

Colido Print Rite DIY

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

10

Category: Sport & Outdoors