Piggy bank with two coin slides for commercial use!

Piggy bank with two coin slides for commercial use! This is a licensed model that will allow you to sell 3D prints!

You can find the model licensed for private use only here: https://www.printables.com/pl/model/705509-piggy-bank-with-two-coin-slides-piggy-castle-bank

========== >> This is an update of the model with a few differences!

General information about the model:

Size: 153 x 108 x 232,5 mm (XYZ).

Maximum coin size for a larger slide: ⌀30x3,5 mm Maximum coin size for a smaller slide: ⌀21x2,5 mm Maximum coin size for direct insertion: ⌀30x3,4 mm

Slide time from the smaller slide: ~ 1,5s Slide time from the larger slide: ~3s

Recomended printing paremeters:

Layer height: 0.2 (or less) Filling: 15% triangles (or other) Perimeters: 3 Support: not required Brim: not required Raft: not required Scaling: I recommend printing 1:1. You can print a smaller model, but remember that this also reduces the size of the coins that can be used! I do not recommend printing less than 80%.

Print time on Anycubic Kobra 2 Pro: 8 hours at a speed of 230 mm/s Filament type: PLA Filament use: ~ 90 m/ ~ 270 g

====

You can sell 3D prints, but sharing or redistributing the 3D file is still prohibited.