Angle Grinder Holder for Multiboard - Won't Fall!

Gone down the deep end on Multiboard? Me too!

Check out my collection of Multiboard Models here!

Comments

Hangs an Angle Grinder from the Protective Sheath. I designed it for my Dewalt DCG416 but likely works with others. The Radius of my Angle Grinder's protective sheath is 14cm/5.5in:

I designed the “hook” to use a 13cm diameter so it fits rather nicely but not snug to the point it would be hard to put the tool back into it's place. It's working beautifully.

I printed it with 4 walls and the flat side down, and with Supports.

To install, you will need two 13 mm Big Thread, Flat Head, Bolt by Keep Making.

And if needed, use this wrench to tighten (I used the OPEN version): Link