License Plate Bracket for KTM 790/890 Adventure/Duke

Finding OEM parts might be difficult to find outside the U.S. therefore having a temporary option can be useful for KTM users of the 790/890 Adventure/Duke models (up to 2021). I created a 3D model based on the OEM Part 64112181100 and created two short versions depending of your taste.

Both short versions only differ from where the reflector will be located. Having the reflector in the top is safer but you need to check your motorcycle laws regarding this reflector, so in case you need to have it at the bottom, there is an option for that.

I tested this brackets with my Ender 3 v2. Be sure of using the right flow rate although I got away with it, having increased the flow 20% -ish and having the holes a little tighter. But I did it just to have more resistant piece. I printed a final version with ASA filament and it's working great so far.

I highly recommend to use supports, because the reflector holder are 27 degrees (67 degrees overhang). It will print without support, but will make it near to spaghetti in the back.