SV08 4010 fan mount

ok i have fixed the old versions flaws and now this works great.

make sure to have the fans blow away from the board. the MCU fan now blows out the original hole.

you can make these changes in your printer.cfg to have the fans use PID.

#[temperature_sensor mcu_temp] #sensor_type: temperature_mcu #min_temp:0 #max_temp:100

#[temperature_sensor Host_temp] #sensor_type: temperature_host #min_temp: 0 #max_temp: 110

[temperature_fan fan2] #header 1 from the left. pin: PA1 kick_start_time: 0.5 off_below: 0.40 max_power: 1.0 min_temp: 0 max_temp: 100 hardware_pwm: true target_temp: 50 shutdown_speed: 0 sensor_type: temperature_mcu max_speed: 1.0 min_speed: 0.38 control: pid pid_Kp: 2.0 ;40 pid_Ki: 5.0 ;0.2 pid_Kd: 0.5 ;0.1 pid_deriv_time: 2.0

[temperature_fan fan3] #header 2 from the left. pin: PA2 kick_start_time: 0.5 off_below: 0.40 max_power: 1.0 min_temp: 0 max_temp: 110 hardware_pwm: true target_temp: 55 shutdown_speed: 0 sensor_type: temperature_host max_speed: 1.0 min_speed: 0.38 control: pid pid_Kp: 2.0 ;40 pid_Ki: 5.0 ;0.2 pid_Kd: 0.5 ;0.1 pid_deriv_time: 2.0

In addition just an FYI.

[temperature_fan fan4] #header 3 from the left. pin: PA3 kick_start_time: 0.5 off_below: 0.40 max_power: 1.0 min_temp: 0 max_temp: 110 hardware_pwm: true target_temp: 55 shutdown_speed: 0 sensor_type: temperature_host max_speed: 1.0 min_speed: 0.38 control: pid pid_Kp: 2.0 ;40 pid_Ki: 5.0 ;0.2 pid_Kd: 0.5 ;0.1 pid_deriv_time: 2.0

[output_pin main_led] pin:PA6 #header 4 from the left. pwm: true value:1 cycle_time: 0.01