Fan Duct for TMC220X Steppers Anycubic i3 Mega S

Fan duct to install on main board of a Anycubic i3 Mega S.

Modification of the original source was needed to install properly 2 Noctua Fans NF-A4x10 FLX and prepared to insert M3 bolts and nuts, giving enough space to the steppers heat sinks. Also, the inner part of the enclosure was modified to perform a better air flow. Additionally, two supports were added to attach the duct to the same bolts of the Main board making the element consistent.

The piece fit quite well, but for mounting, in my case, I had to remove the power supply prior to place it in position.

There is no need to configure any supports (there are some supports already created on the model).

I recommend the use of PETG or ABS in order to hold higher temps during its use.