AOS 7 DJI O3 GoPro 9, 10, 11, & mini, Antenna, Immortal t, Matek M8Q GPS, and Arm Guard

This is all the 3D printed parts I used to build the AOS 7 DJI O3 Quad.

More details about my build here: https://rotorbuilds.com/build/30453

This is 2 versions of the FPV camera mount. One with the vibration dampener silicon grommets and one without. O3 CamMount 20deg v13 Grommet.stl O3 CamMount 20deg v10.stl

These are the spacers I used on each ends of the 20mm standoffs for the FPV camera mount. I did this so it is easier to print and so you do not need to use any supports. The reason why there are different size depends on how tight you screw it in. 1mm is what you use if TPU does not compress when you tighten the screw. But we all know it does so 1.5mm might be ideal for most people and 2mm for those who likes to over tighten everything.. lol 1.5mm Spacer.stl 1mm Spacer.stl 2mm Spacer.stl

If you plan to use the original DJI O3 Antenna you will use this mount. FpvAntennaMount_v5.stl

But if you want to use a ufl to SMA (RP-SMA) converter so you can switch to a different antenna with this mount. There are 2 different versions of this mount one that is open that allow the battery cable to exit and one that is closed. The GPS is for the Matek M8Q-5883 GPS or iFlight M8Q-5883 V2 GPS 60DoubleSMA_RX_MicroGPS_r1 v04.stl (closed) 60DoubleSMA_RX_MicroGPS_r1 v07.stl (open)

This is the remixed arm guard of this file on thingiverse. ArmGuard_thin.stl

Here are a few variations of the GoPro 11 Mini mount. It is kind of complicated to source all the parts because I Frankenstein it together with a few different files. Clevis_gopro_11_mini_v19.stl HERO_11_MINI_v3 20Degrees.stl HERO_11_MINI_v2 NO BASE.stl

This is a mount for the Full size Gopro 11 with the Clevis pin so you can easily open the case to mount the Gopro. v1-main-gopro-mount_03.stl