CNC hold downs and clamps

Just a bunch of clamps I've designed for use with my CNC Router. I'm sure they could be used in other applications also.

If your hold down points are spaced more than 50mm, make sure use the longer side and flat clamps or you may not have the necessary reach.

I sized the holes to use with M6 or 1/4FU (freedom unit a.k.a. inch) bolts to secure to spoil board and M5 x 25-30mm for the toe clamp's angled studs.

If they get enough likes, I'll make the effort to learn how to make them customizable on here.

Oh, and remember to pat your stock a couple times and say "that isn't going anywhere" before you start or it'll come loose during the job. Good luck out there.